While there are a couple of open-source brushless drivers already available, [neuromancer2701] created his own brushless motor controller on an Arduino shield.

An interesting Arduino project has been published to the Instructables website showing how an Arduino CNC shield and controller has been used to create an awesome 3 axis Arduino CNC plotter.

The High Power H-Bridge Motor Shield for Arduino is equipped with built-in current sensing utilizing the ACS712, and is capable of driving any DC motor up to 15Amp.

Enrico shows how his Infineon TLE94112EL motor controller shield can be put to work through a simple Arduino sketch.

The Arduino has been used for many purposes, and “shields” are available to make many common tasks easier. However, [Nick] wanted a stackable motor driver shield, so he build one himself!.

Making a servo tester using an Attiny85 micro chip, Attiny45 also works for this project. This diy servo tester is as good as ...

1x Arduino Uno R3 1x Arduino Motor Shield R3 1x Hobby Servo 4x M3 x 40mm Screws With Nuts 1x HC-SR04 Ultra Sonic Sensor 2x 480 OHM 1/4 Watt Resistors 2x 5mm White LEDs 1x 9V Battery Clip ...

This solar tracker system uses the Arduino UNO board, a servomotor, 2 LDRs and 2 resistors to rotate the solar panel towards the Sun or a source of light.

Pretty much every project I've done just lately has required me to test out some servos and experiment with their positions before they go into the assembly. I usually make a quick servo tester on ...